P03 – Tracking Photocharges in Space and Time

Revealing Photocharge Dynamics, Atom by Atom

PI: Laerte Patera, University of Innsbruck

Project P03 develops and applies advanced microscopy methods to follow photoexcited charge carriers on oxide surfaces with atomic-scale spatial resolution and high temporal sensitivity. In photocatalytic materials, light generates electrons and holes that must reach active surface sites before they recombine. However, the precise pathways, trapping sites, and lifetimes of these charges remain difficult to access experimentally, especially on structurally complex oxide surfaces.

P03 addresses this challenge by developing time-resolved atomic force microscopy approaches for studying photocharge dynamics in binary and ternary oxides. The project combines pulsed laser excitation with low-temperature atomic force microscopy to detect local charge distributions after light absorption. This allows the investigation of where photocharges localize, how they migrate, how they become trapped as polarons, and how they recombine.

A key strength of P03 is that atomic force microscopy can operate on materials that are not sufficiently conductive for conventional scanning tunneling microscopy. This is crucial for many oxide photocatalysts, where insulating or semiconducting behavior limits the applicability of other atomic-scale techniques. By using force-based detection, P03 can access charge phenomena on model oxide surfaces prepared by Project P02.

The project will first characterize photoinduced charge localization under illumination and then move toward pump–probe measurements, where the time delay between optical excitation and microscopic detection is varied. This strategy will provide dynamic information on carrier migration, trapping, and recombination. The resulting maps will identify how defects, dopants, and surface terminations influence charge separation and charge lifetime.

P03 is closely connected to the other POP subprojects. It relies on atomically defined oxide films from P02 and provides experimental benchmarks for the simulations developed in P04. The data generated by P03 will help refine theoretical models, while computational predictions will guide the interpretation of microscopy contrasts and charge dynamics.

By producing atomic-scale, time-resolved insight into photocharge behavior, P03 will provide a new experimental window into the fundamental processes that control photocatalytic activity. Its results will support the rational design of oxide materials in which defects and dopants are used to improve charge separation, extend carrier lifetimes, and enhance catalytic performance.